Controls & Steering

Use for all inboard/outboard, outboard, and inboard Seastar hydraulic helms. Kit includes: hose with screw cap which fits SeaStar or equivalent oil bottles and push pin for venting/resealing bottle. Allows for clean bleed when used properly.

Hardware kit for single or dual station installations. For use with 3300/33C type cables only.

Quick Connect II for helms with threaded spigots SA27620P (upgrades older Teleflex/Seastar Solutions rotary helms to Quick-Connect cable interface, allowing use of SSC61/SSC62 QC cables).

Square backplate kit for the 5271 and 5272 SeaStar helms. Used to retrofit new Seastar standard helm into hole cutouts

The SeaStar cylinder allows for the periodic required realignment of two outboard motors or rudders that are linked together with a hydraulic tie bar as opposed to a solid link or a mechanical tie bar. Hydraulic tie bar SeaStar alignment valve may be...

This kit is for use with CC170 series cables, 35HP and below, 1973-78.

Kit adapts 33C or 33C supreme for use with Evinrude/Johnson 55-235HP 1978 to 1985, 20HP and up in 1986, 20-25-30HP motors may need OMC kit 397488.

Installed at control end of cable to fight throttle creep. For 3300, 4300 and 6400 series.

Easily converts standard Bennett hydraulic trim tab systems to Bennett BOLT electric trim tab systems. Simply replace your Bennett hydraulic actuators and pump with the new Bennett electric actuators and relay module. You will still be able to use your...

This kit is for use with CC170 series cables, over 35HP, 1973-1978.